How to load labels into smart label printer 620
Setting up the Printer
If the printer is not recognized using the installation wizard, you will need to set up your printer manually.
To do so, follow these steps:
Prepare the Roll of Labels
1． Open the Smart Label printer software.
2． Under the Label pull-down menu, select Printer Set-up.
3． Select Add a printer.
4． Select how your printer is connected and click Done.
Loading a Roll of Labels
Prepare the Roll of Labels
1． Remove the sticker from the beginning of the roll of labels.
Note: Make sure there is a black mark on the label backing as shown in
"A WORD ABOUT LABELS".
2． If necessary, cut between the labels to create a "leader".
If the end of the roll is not prepared as shown above, cut between the labels leaving as much backing as
possible on the end of the roll to act as a leader.
Load the Roll of Labels
1． Make sure the power cord is connected and the printer is turned on. The green Status Light should
be flashing.
2． Press the left and right side of the Roll Cover, and lift up the edge of the Roll Cover to open.
3． Remove the Spindle from the SLP and insert the label roll into the Spindle.
4． Insert the labels and Spindle into the SLP. Adjust the guides to fit the labels as shown below.
SLP provides three types of labels which have different paper width. Insert each label into
positions shown in the figures below.
5． Insert the free end of the label roll, label side down, into the paper inlet slot. Push the label stock into
the paper inlet slot until you feel a slight resistance. Continue pushing gently. The SLP automatically
feeds the labels through and aligns the end in the exit slot.
If the label end doesn't appear through the exit slot:
Press and release the Form Feed Button to advance the labels.
6． Close the Roll Cover. At the time, be careful not to close the Roll Cover on your fingers.
No comments:
Post a Comment